Установил ремень вариатора на Honda Forza (MF 06).Качество материала хорошее,износостойкий .Легко позволяет набирать скорость 120 км/час.Established a variator belt on Honda Forza (MF 06). Material quality is good, wear-resistant. Easily allows to gain speed of 120 km / h.translated by Google Translator
Very good belt for the cost. I have put this belt on HONDA LIVE DIO-ZX, without having found a belt with a size of 18х667. Apparently in the photo the belt the trifle doesn't reach edge of a pulley of a torque driver's, he at me with a diameter of 118 mm. But nevertheless I haven't felt decrease in the maximum speed. Inscriptions on a belt say that it is made in Taiwan, considering its cost it is just a gift. I hope a resource of a belt me won't disappoint.View Detail
This belt is good and high quality. I have been using this belt for a year now with a 61mm bore in my Suzuki Address V125G. No problem at all even with powerful engine. View Detail
Installed a week ago. It went out the day before yesterday. The situation is that it cut out on RoseRose. I want to contact the manufacturer. I would like to contact the manufacturer. I will return the full amount of the Gold and explain the situation. Why are you selling a bad product? I will send you pictures or return it to you. Please reply as soon as possible. Thank you very much.View Detail
On the 2001 Honda Forza MF 06, after 15,000 km, the suspension bearing of the right rear wheel hummed. Replaced with NTN products. After that I drove 3000 km, I'm happy with the result. When pressing in the bearing, so that the seat does not wobble, you first need to heat the suspension part with an industrial hair dryer to a temperature of 150 degrees C. This product has a metal protection for the balls, bearings with a plastic ring are installed on the scooter at the factory.View Detail
This chain is used on a Honda MTX 50 and is used in tough off-road conditions. In the mountains, in swampy areas, when overcoming water obstacles up to 0.5-0.6 m deep, the DID STD Series Chain 420D Steel shows itself only positively. It retains its size (does not stretch) when used in enduro conditions no less than for 1000 km.At the same time, it works constantly in mud and with a lack of lubrication.View Detail
After 10 years of operation of the maxiscurator, the grease dried up in the drain bearings and they became unusable. A play appeared on the wheel. I replaced them with Koyo bearings. I need to remove old ones and put new bearings on the wheel’s hot disk, it must be heated with an electric hairdryer. After replacing the bearings Koyo passed 5000 km without any problems.View Detail
On my Honda NSS 250 mf 06 maxiskooter, when the steering wheel was turned too hard, the windshield was touched by the risk of breaking it off. I installed the Ai-net Mirror Adapter (10 mm thread, 1.25 pitch) to the right and left. As a result, the mirrors began to be above the fairing . Adapters are made of high quality, most likely stainless steel. They look good, the exterior of the scooter does not break.View Detail
Iridium candle was installed on a 2-stroke air cooling Suzuki K 125 motorcycle. The engine on it starts confidently, works well both at medium (3500-4500) and at high speeds (7000-8000). There are no spark plugs in the ignition. The engine pulls well.The carburetor adjusted to a normal mixture, not poor and not rich, brown soot, the motor does not overheat.View Detail