【制造商保证期】6个月(或安装后最多5000公里)
【安装时间】取决于车辆
【握柄长度】
。右侧:手柄115mm+项圈5mm(X2)
。右侧:手柄115mm+开关8mm+项圈5mm(X2)
左侧:手柄115mm+开关8mm+项圈5mm
【手柄直径】ø34
【功耗】8-40w
【尺寸】(约)
。附件电源连接套件主体:22.3 x 37.8 x 36.5
。配件电源连接套件连接器:ø3.5
【产品内容】
请参考使用说明书
。握力加热器sp×1
。附属电源连接套件×1
。子线束×1
。
*请根据车辆的真正握持长度来决定项圈的使用。
本产品为通用型产品,根据车型不同,可能需要改装或更换零件。
本产品为通用产品,根据车型不同,可能需要进行改装和配件。
请勿与HID套件和外部点火线圈等产生高电压噪音的产品同时安装。本产品仅适用于具有正常电气系统的汽车。
*请注意,本产品不适合在海外销售的车辆、125cc或以下低功率输出的车辆或旧车。可能无法使用这种产品。
*在通用型的情况下,有必要修改附在车辆上的节气管,或购买单独出售的节气管。
*请不要赤手空拳使用手柄加热器,因为它会变得非常热。
请不要赤手空拳地使用手柄加热器,因为它将非常热。更多信息,请参考使用手册。
* ptc热敏电阻被电流的热量切断,通过切断后的电流量和经过的时间,它的温度变得非常高。在这种情况下,它可能会使设备变形或熔化,这是非常危险的。
* 避免将附件电源连接套件安装在可能过热的地方。
*附件电源连接套件的主机是防水的,但终端部分应进行处理,使其不与水接触。
附件电源连接套件是为20A的高功率输出而设计的,但不是所有的车辆都能使用20A。
*附件电源连接套件具有20A的高功率输出,但并非所有车辆都能使用20A。
* 安装时间是基于这样的假设:你是一个合格的机械师,具有摩托车维修的一般知识和技能,并且你已经拥有必要的工具。
*我们没有检查过所列举的以外的其他车型的适用性。我们没有检查过其他型号的产品的适用性。
※我们还没有确认除所列型号外的其他型号的安装。
*我们不保证将产品安装到未列入兼容车型的车型上。
*当握把加热器通电时,握把会发出呜呜的声音。
*产品的颜色可能因拍摄条件、显示器、产品批次或套装产品的左右而有所不同。我们不接受任何交换。
* 请注意,由于制造商的原因,产品规格可能会有变化。请注意这一点。
[Installation time] Varies depending on the model
[grip length]
・Right side:Grip 115mm + Collar 5mm (x2)
・Left side:Grip 115mm + Switch 8mm + Collar 5mm
[Grip diameter] Φ34
[Power consumption] 8-40W
[Dimensions] (approx)
・Accessory Power Supply Connection Kit Unit: 22.3 x 37.8 x 36.5
・Accessory Power Supply Connection Kit Bullet Terminals: Φ3.5
[Product Description]
Refer to the instruction manual
・Grip heater SP x 1
・Accessory Power Connection Kit x 1
・Sub Harness x 1
*Decide the use of the collar according to the length of the stock grip of the vehicle.
*Because this product is a universal product, modification or parts may be required depending on the model.
*Please do not install the product which emits high voltage noise such as HID kit and a third party ignition coil together.This product is only for vehicles with stock electrical system.
*Please be careful when installing the product on "vehicles sold overseas", "vehicles with a low power output of 125cc or less", and "older vehicles".You may not be able to use it.
*In the case of the universal type, you need to modify the throttle tube attached to the vehicle or purchase a throttle tube separately.
*Please do not use the grip heater with bare hands because it becomes very hot.
*Please be careful even with gloves on, as there is a risk of low temperature burns.For details, please refer to the instruction manual.
*PTC thermistors are cut off by the heat of the current, and become very hot depending on the amount of current and elapsed time after cut off.In this case, it may deform or melt the main unit, which is very dangerous. Remove the interrupted device from the main unit as soon as possible.
*The main unit of the accessory power connection kit generates heat, so avoid installing it in a place where it is likely to be overheated.
*The main unit of the accessory power supply connection kit is waterproof, but the terminal part must be treated so that it is not exposed to water.
*The accessory power connection kit has a high output of 20A, but not all vehicles can use 20A.Depending on the vehicle, battery condition, or other factors, the load on the battery may increase, which may cause the battery to run out of power.
*The installation of models is not checked other than those listed in the compatibility check list.If your vehicle is not listed, it cannot be installed or has not been tested.
*The installation of the product to the models that are not listed in the compatibility check list is not guaranteed.
*As the grip heater is energized, there is a whining sound from the grip, but this sound is not abnormal.
*The color of the product may vary depending on the shooting conditions, monitor, product lot, and left and right of the set product, but returns or exchanges is not accepted.
*There may be changes in product specifications due to the manufacturer's reasons.