可调式牌照架

The Fender Eliminator is great for achieving a tidy and short tail. The product is well made and fit for the bike. The only problem is that it it a little bit long for the licence plate of Hong Kong. Otherwise it is perfect. Recommend to anyone who want a clean shape of bike.

As for the installation, the existing 4-point Bolt is long enough to install on the vehicle, so I installed a shorter Bolt instead.Other than that, it came with no other processing.The Wiring process needs a little work to make it less noticeable.Unlike the Fender Eliminator, which is too short, I think it provides some mudguards.I like the look and feel of Balance quite well.

The Fender Eliminator Kit by FOR JAPAN MODELManufacturer is too short and I'm worried about mud splashes, but since this product is quite long, I bought the Complete kit.The texture is a little cheap for the price, but sufficient for the need.There are two main problems.The first one is that when using OEM Blinker, Screw hole of Blinker Bracket is obviously too small, so it was extended by Drill.Secondly, the Parts that are installed on the car Both Sides do not match the width of the design. This is why I had to put Quantity:Pair (for Left and Right) It was installed by biting the Spacer for a total of 20mm of 10mm each.Also, although not a problem, I felt that the Blinker and License Plate Light wiring process was difficult because they are quite a bit longer in length than the competitors' products.Not sure how much mud bounce there will be as I haven't driven it on a rainy day yet.I've said a lot of things, but so far I haven't seen the body with it installed in person or on the net, so it doesn't look like anyone else, and I'm happy with the shape of this product, which is a shorter version of the OEM Fender.

I installed it on my 2019 MODEL YZF-R6The angle of the Number, the length of the reflector, and the position of the blinker can be adjusted There are manyInstallation is a bit cumbersomeWiring of License Plate Light is not a Bullet Terminal process It is necessary, but it is difficult to install Bullet Terminal because the wire is too thin I reconnected with a thick wire, but if it is made a little longer, it can be bent and made thicker I thought it was a good ideaYou must be careful when installing the License Plate Light or the screw holes are likely to collapse This is the one I used double-sided tape to attach it to the wall because I crushed itIt is attached to the MotorcycleBody using the OEM Screw, which is attached to the back of the bike Wrench doesn't go in because there is not much clearance though it tightens up with Bolt Hmm..You can detach the FenderBody from the Motorcycle connection and the FenderBody, so you can detach it from the Wrench was about to go in I was so fucking cumbersome that I pinched the Bolt between the thin Pliers and tightened it up, but I thought it was probably not enough It is