原厂轮框、5mm厚 270mm碟盘、原厂后摇臂用
规格:Brembo卡钳对应
【对应碟盘】
・原厂前用270mm
・SUNSTAR前用T-83HZ/270mm 厚度5mm用
*不支持外轮。
(由于使用原厂扭力杆,外宽轮会与轮胎接触。)
※外摆臂没有出厂时的扭力矩轴承,不能安装。
※为了防止与后悬架的储水箱接触,需要进行改装。剪下方板,确定扭杆固定螺栓后侧螺母的角度,从正面插入正品螺栓。
Stock wheel, 5mm thick 270mm rotor, for stock swingarm
Specifications: Brembo caliper compatible
[Compatible rotors]
・For stock front 270mm
・Sunstar front T-83HZ / 270mm for 5mm thickness
*Not compatible with aftermarket wheels.
(Since stock torque rods are used, the torque rods will come in contact with the tires on aftermarket wide wheels.)
*The aftermarket swingarm cannot be installed without the stock torque rod support.
*Modification is required to prevent contact with the reservoir tank of the rear suspension.Cut off the square plate on the back side of the torque rod fixing bolt to set the nut angle, and insert the stock bolt from the front side.