【平稳驱动系统】
平稳驱动系统,针对不同类型的车制定最合适的套装。
绝缘子带、喷油螺栓、空气净化器箱、悬架等
静止费被取消。它是一个放电的系统,使流体流动顺畅。
平稳驱动系统不算是所谓的调校部件。
他们是把原来的问题解决的部分。
自丰田铝带公布以来,大众已经意识到静电的问题。
平稳驱动系统中的螺栓。螺母通过空气放电(电晕放电)消除螺母锯齿尖端的静电。
静电荷是正电荷或`-电荷的盈余。
这些条件总是发生在所有物质 "动 "的情况下。
有时会在瞬间中和或接地而失去。
最好在产生静电的地方消除静电。<可以通过移动静态来删除,但会影响沿途的一切。
静电路径中的悬浮物可能会影响运动。
在进气系统中,它对外界空气的 "导入 "流和混合空气的 "流入 "流起到阻力作用。
所谓的 "砰砰 "现象可能是由于绝缘体的静电荷导致混合气不能顺利进入发动机。
到了一定程度,进气力失效,混合气一下子进入,造成粘滞。
唐突也是一种时间差。如果没有躲避,说明从初期就可以加速。
从早期阶段开始的平稳加速意味着您可以达到目标速度,而无需比以往更多地打开油门。
行驶越平稳,驾驶越轻松,越安全,打开油门踏板的时间越少,行驶里程就越好。
越早加速,你的时间就会越好。这也是电摩车速度较快的主要原因。
绝缘子带螺栓减速
更换原绝缘子带螺栓即可!是。
使用橡胶绝缘子的内燃机一直在充电。
喷射器。至于化油器,它可以防止静电在车体本身积聚,防止吹油的理想状态。
只要空气净化器外壳和进气管是塑料的,进气口就不能带电,无法顺利吸气。
光滑的感应(黑网)消除了机箱内的静电。<对于不能安装的部分,涂抹双向涂层可以防止静电产生。
[Smooth drivetrain]
Smooth Drive Systems has developed the most suitable set for each model.
Insulator band, injection bolt, air cleaner box, suspension, etc
This system eliminates and discharges the static electricity and makes the fluid pass through smoothly.
Smooth Drivetrain is not considered as a tuning part.
It is a part that brings the original problem to a solution.
Since the announcement of Toyota's aluminum tape, the general public has come to recognize that static electricity is a problem,
For more than 30 years, there have been various static electricity-related products for vehicle, but they have been repeatedly released and disappeared.
The bolts and nuts included in the Smooth Drivetrain eliminate static electricity by aerial discharge (corona discharge) from the serrated protrusions on the tips.
Static electricity is a state in which there is an excess of either + charge or - charge.
That state always occurs in every situation when matter "moves".
Rubbing, spinning, flowing, bending, temperature difference, but it can be neutralized instantly by +- or grounding and disappear.
It is best to remove static electricity at the point where it is generated.
Removing static electricity can be done by moving it, but it will affect everything along its path.
The suspension is in the path of static electricity and may be affected, resulting in poor movement.
In the intake system, it resists the introduction and flow of outside air and the inflow of the air mixture into the engine.
The so-called "thump" is probably caused by the static electricity of the insulator pulling the air mixture and preventing it from entering the engine smoothly.
If the static electricity of the insulator is removed and the air mixture enters gradually, the sticking will be less.
Thump also leads to a time lag.The lack of thump also means that you can accelerate early on.
The ability to accelerate smoothly from an early stage means that you can reach your target speed without having to open the accelerator more than before.
If you can drive smoothly, it is easy and safe, and if you open the accelerator pedal less, or open it less time, fuel consumption will naturally increase.
The earlier you can accelerate, the better your time will be.This is one of the main reasons why electric motor vehicle have better times.
The insulator band bolts are used to slow down the power of the insulator
Just replace the original insulator band bolts!It is.
Internal combustion engines that use rubber insulators are always electrically charged.
As for injectors and carburetors, it prevents static electricity from accumulating on the body itself and preventing the fuel from blowing ideally.
As long as the air cleaner case and intake pipe are made of plastic, the intake air will be charged and will not be smooth.
Smooth Induction (black static dissipative mesh) removes static electricity from the case.
For the parts of the case that cannot be installed, apply Two Way Coat to reduce static electricity generation.