最高回转数(Daytona 公司指定):11.000rpm
*需要对曲轴箱进行镗孔(56.6-56.8mm`深度27mm)。此外,戴托纳不进行曲轴箱镗孔。请请专家来做。<振动和发动机噪音会随着缸径的增大而增大。<油温必须用油冷却器和油温计来控制。如果在高温下(超过100℃)连续运行,发动机可能会损坏。
*由于功率会增加,建议同时使用以下部件。如果用以下零件作为正品零件,发动机可能无法承受功率的增加而损坏。
同期配件
加强主侧三盘离合器套件(95634)
Mega油泵2型(74670)
加强凸轮链(77415)
。
Maximum RPM (Daytona Specifications): 11.000rpm
*Boring of the crankcase (56.6-56.8mm, 27mm deep) is required.Daytona does not perform crankcase boring.Please contact a specialist.
*Increases vibration and engine noise with increased bore.
*Install an oil cooler and an oil temperature gauge to control the oil temperature.Continuous running at high temperatures (over 100°C) may damage the engine.
*Because the cylinder length is about 6mm longer and the head is larger than stock, there is a possibility that the head may contact with the tire depending on the combination of the suspension.
*The carburetor and exhaust must be replaced to achieve the specified performance.
*Due to high compression, use high-octane gasoline.
*Because of the increased power, it is recommended to combine with the following parts.If the following parts are used as stock parts, the engine may not be able to withstand the increase in power and may be damaged.
■Parts to be installed at the same time
Primary side reinforced 3 disc clutch kit (95634)
mega oil pump type2 (74670)
Reinforced cam chain (77415)