Parts Shop K&W Lower Ring 降低连杆(狗骨头)套件
Do not buy this lowering kit for your Big Boy 250.
The hole does not fit on the bolt, cannot install at all.
Rough welding with simple thick steel plate, this also may harm your OEM swing arm....
 |  |  |
| | | |
 |  |  |
| | | |
 |  |  |
| | | |
 | ||
| |
Parts Shop K&W Bolt-on Mid control套件
1. Female Screw defect in mounting part of Change Pedal. (Namelu putting male Screw)2. If you do KICK you will be caught by Footpeg Holder and will not come back.3. Accuracy of mounting hole is bad an...
Parts Shop K&W Corn 全段排气管
Bending is dirty with a PRESS trace attached. Machining accuracy is also bad, so it can not be installed properly. It seems that neither responsibility nor Pride exists for the production.
Parts Shop K&W 圆型后视镜
I would not recommend these mirrors. Bye this to my Yamaha Wild Star 1600. The mirrors started to rust right away. Poor quality.
Parts Shop K&W 16吋铁框后轮框(轮毂)套件 (鼓煞用)
For the first time I made this kind of poor accuracy Rim. Nipple jumps out on the Tube side even if the Nipple dent of Rim is made shallow. It is not Ginya Nya that is not the Level of Rim's freak...
Parts Shop K&W High Mount SportStar 油箱
DO NOT BUY THIS TANK !! ITS THE WORST EVERYTHING WELD HAS FAILED MORE THAN ONCE.THE METAL THEY USED IS WAY TO THIN AND WORSE THE FRONT MOUNTING POINT ON THE FRAME IS meant TO HOLD A LITTLE EVSP CANIST...
Parts Shop K&W 不锈钢制侧盖
Mainstreaming at other manufacturers is PlatingThis item is Stainless SteelAs long as you do not polish, you will lose the glow but feel safe without rustingIf you are going to use it for a long time,...
Parts Shop K&W 前叉固定式后视镜支架
Even though the motorcycle is stored inside at night, after a month of installing them, there are rust marks all over them. Would not buy again.
Parts Shop K&W 点火线圈变更位置组
Paint is necessary as it is iron.Clear If you do paint polishing is also rough so you need polishing as well. Probably it is a painting premise.I need a little effort, I think whether Coil can be relo...
Parts Shop K&W Cobra 坐垫
The part fixing SeatRearBolt is the same as the resin on the back side (Seat back resin only extended length) So strength is not enough at all.I was damaged at the time of installation.Since I install...
