NA Metal Craft 降低连杆套件
The delivery is quick and good, it still before installation, but the quality is too good
I'll review it again after installation
The delivery is quick and good, it still before installation, but the quality is too good
I'll review it again after installation
These were slightly narrower than my stock handlebar mounts but the contour and holes in these risers matching perfectly with the stock mounts. Finish matches stock as well.
I usually use the w1 handlebar, but the height was a little disappointing. I raised it exactly 24mm to make it perfect. The quality of the product is also great!
About quality and texture - Top quality. Nicely machined stainless steel pick up spools perfect for my Sharp Racing rear paddock stand.
About the feeling of use - I leave these fitted to the Monkey a...
The quality and texture are good.Even if you have a NORMAL suspension, this is a great way to easily improve the custom feel and footing with 20?Lowdown&Lay-down.It is important to note that the angle...
pure quality , perfect fit and sits nice next to the gold caliper , very high quality , and will never rust great , brembo calipers are next on the bucket list , then ohlin rears
There was no difficult process, and the installation time was roughly 30 minutes.Since the position of the Suspension is shifted back, the rear part of the Chain Cover is slightly different from the S...
Installed on W800Position is now easier (Leaning forward has softened.)Accelerator WireOthersWiring can be changed in Position without extending it.It is recommended because it can be done without rem...
I replaced the NORMAL Handlebar Clamp with this one because it was black, and the Top Bridge and Holder are also black, so it looks a bit out of place, but I'm generally satisfied.
如要继续浏览此商品,请点击"前往Webike日本站",将引导您去Webike日本站(日文)继续浏览此商品。